Hambini BB30A Cannondale CAAD Installation
StylishRiding, a viewer of the Hambini Channel videoed their installation of a Hambini BB30A to Shimano bottom bracket and uploaded it. You can view it below
Fresh from YouTube is another Hambini Bottom bracket install. This time in a Yoeleo R12. This is a revision of the R11 bike Frame that The Unabiker had issues with and it highlights the problems of frame tolerances. The bottom bracket is made to much tighter tolerances than the frames they are pushed into.
A Hambini bottom bracket user from Canada sent this link to their mechanic installing a Hambini BB into a Cervelo bike frame. The music and install are quite therapeutic!
9Velo is a relatively new company, but the individuals behind it have been in the carbon fibre wheel industry for a considerable length of time. These gravel wheels have some of the highest levels of manufacturing quality that I have ever seen. The hubs are probably the best ones you can buy; they make DT Swiss units look like rough copies in comparison.
The Winspace Hyper are highly regarded, they have very good aerodynamic properties and are comfortably one of the fastest wheels you can buy. The Winspace hubs use standard 6000 series bearings of common sizes. This video shows you how to remove the bearings and replace them if they are worn or you want a bit…
This post provided aerodynamic performance data for wheels using disc brakes.
Introduction Shimano have had some issues with their high end cranksets in recent times. It seems as though the Ultegra and Dura Ace cranksets are the primary units affected. There have been many reports of the cranksets fracturing in half. Some of these have been under modest load on turbo trainers whilst others have been…
No products in the cart.
Awesome, KUDOS! I have one question. I have Caad 12 Disc version, so is there enough space for hydraulic tube for rear disc brake?
KUDOS again!
The centre section of this BB is the same size as a 30mm crank so it has the same amount of clearance. If your hydraulic lines fit in that envelope then this BB should work.
Did you manage to get this to work with hydraulics? Having a few issues here.