Increasing the length (stack height) of a Fork Steerer (Cut to Short)

| |
Bike Steerer Tube Extension

Warning

The recommended method of fixing a fork that has been cut to short is to replace it. This method used in this post has some limitations and may be beyond the scope of stresses of the steering system.

Introduction

One of the most common occurrences with bike fit is adjusting the height of the handlebars. This is usually accomplished by the addition or removal of spacers beneath the stem. However, in some situations the cyclist may find his fork steerer is too short and they require an additional increase in height. The recommended method to solve this problem is by purchasing a new fork but this is not always possible.

One method to solve this problem is to use the compression bung as an extension of the fork steerer. This was originally developed when the famous £50 Look bike was purchased and had a fork that was too short. In that case, the bike was long out of production and used a now uncommon 1 inch diameter steerer.

This method uses a common OEM generic far eastern headset bung and compression assembly and replaces one part. This is available in various brand names including M Part, FSA and others

image 2
Generic OEM Headset Bung Assembly

The diagram below shows the assembly within the contexts of the bike frame and a photograph of the extended steerer tube by approximately 20mm

A key point in this setup is to ensure there is a gap between the top cap and the yellow Modified Expansion Plug. The gap is required to ensure sufficient preload of the headset system.

Bung Schematic
Assembly Zoomed in

Potential Issues

One of the potential pitfalls of this is to ensure the fork has been cut squarely. Note the slight gap between the silver part (the extension) and the black part (the OE tube). This would need to be rectified.

Steerer Fork Extension
Steerer Fork Extension

Watch on YouTube

The video below shows the schematics and build up of this method

The video below shows the bung assembly in a live bike

Links to Parts and Drawings

  1. Link to Generic Headset This is sold under various different brands in differing markets, but it is almost ubiquitous on generic bike frames from China
  2. Link to Drawing (Patreon Subscription required)

Similar Posts

COMMENTS! Please leave a reply to add to the discussion! NO NEED TO REGISTER!

8 Comments

  1. Your fix to dislodge the seat post is brilliant. However I’m finding it difficult to find Scale X in small quantities/price. Do you know of other products that would work?