Hambini BB30A Cannondale CAAD Installation
StylishRiding, a viewer of the Hambini Channel videoed their installation of a Hambini BB30A to Shimano bottom bracket and uploaded it. You can view it below
A Hambini viewer recently enquired about a bottom bracket for his Cannondale TopStone Gravel bike. This bike uses a BB30A83 bottom bracket. A design which is highly unusual, extremely rare and unique to Cannondale. From the frame centerline, the driveside and non drive side apertures have an asymmetrical offset – hence the “A” in BB30A83….
Paul Green of Paul Green Vlogs got in touch about some problems he’d been having on his Trek Checkpoint bike. He had gone through bottom brackets at quite an alarming rate. Almost four bottom brackets from different manufacturers had become unserviceable in a relatively short time. The failed bottom brackets consisted of a few Shimano OE units and most recently a Thread Together type BB from Wheels Manufacturing. The bottom bracket type was BB86 and the frame was made of aluminum.
Bicycle wheel balancing is a topic that is often discussed but has not ever been dissected in detail. A lot of professionals balance their wheels and this has filtered down to the amateur ranks wishing to eek out the maximum amount of performance. This post will look at the engineering behind the balancing of bicycle wheels.
Introduction Speedplay is a cycling components company that specializes in designing and manufacturing high-performance pedals for road and off-road cycling. The company was founded in 1991 by Richard Byrne, who was a mechanical engineer and avid cyclist. Speedplay pedals are known for their unique design, which uses a double-sided pedal, with the retention system mounted…
Shimano has recently launched the CUES groupset. This amalgamates 9, 10 and 11-speed options for flat bar bikes. There are rumours this will move to drop bar (ie road/gravel bikes) in the near future.
Documents filed with the FCC (The body governing radio communication within the United States) suggest that Campagnolo will introduce a wireless groupset soon.
No products in the cart.
Awesome, KUDOS! I have one question. I have Caad 12 Disc version, so is there enough space for hydraulic tube for rear disc brake?
KUDOS again!
The centre section of this BB is the same size as a 30mm crank so it has the same amount of clearance. If your hydraulic lines fit in that envelope then this BB should work.
Did you manage to get this to work with hydraulics? Having a few issues here.